Synchronising Tcp/Ip Settings With The Gigaset Se551 Wlan Dsl/Cable - Siemens gigaset SE551 Owner's Manual

Configuring the local network

Synchronising TCP/IP settings with the Gigaset SE551 WLAN dsl/cable

You have now configured your PC so that it is ready to be connected to the Gigaset
SE551 WLAN dsl/cable. You now have to release the old TCP/IP settings and synchronise
them with the settings of your Gigaset SE551 WLAN dsl/cable.
ì
Click on Start on the Windows Desktop and then Programs, followed by Accesso-
ries and finally Command prompt.
ì
In the Command prompt window, enter the ipconfig
/release command and press the ENTER key.
ì
Then enter the ipconfig /renew command and press the ENTER key.
If the default IP address (192.168.2.1) of the Gigaset SE551 WLAN dsl/cable was not
changed, the IP address should now read 192.168.2.x (with x being a number
between 2 and 255). The Subnet Mask must always be 255.255.255.0 and the
Default Gateway must have the IP address of the Gigaset SE551 WLAN dsl/cable
(192.168.2.1). These values confirm that your Gigaset SE551 WLAN dsl/cable is
working.
ì
Enter exit and press the Enter key to close the Command prompt window.
32