Table of Contents
Advertisement
Remote Commands
Follow the commands below to access features remotely. When you call the fax
machine and enter your Remote Retrieval Access Code (1 5 9
will signal you with two short beeps to enter a remote command.
Remote Commands
95
Change Fax Forwarding
/Paging setting
1 OFF
2 Fax Forwarding
3 Paging
4 FAX FWD No.
6 Fax Storage ON
7 Fax Storage OFF
96
Retrieve a fax
2 Retrieve all faxes
3 Erase fax from the memory
97
Check the Receiving Status
1 FAX
98
Change Receive Mode
1 TAD: ANSWER MACH.
2 FAX/TEL
3 FAX ONLY
90
Exit
10 - 4
R E M O T E F A X O P T I O N S ( N O T A V A I L A B L E F O R C O L O R F A X E S )
Operation Details
If you hear one long beep, the change is accepted. If you hear three
short beeps, you cannot change it because the conditions have not
been met (Example: registering paging number). You can register
your fax forwarding number by using 4. FAX FWD NO. (see page
10-5). Once you have registered the number, the fax machine will
change automatically to FAX FWD:ON mode.
You can turn FAX STORAGE to ON or OFF.
Enter the number of a remote fax machine to receive stored fax
message(s). (See page 10-5.)
If you hear one long beep, you can erase fax message(s) from the
memory.
You can check whether your fax machine has received any faxes.
If yes, you will hear one long beep. If no, you will hear three short
beeps.
If you hear one long beep, you can change the Receive Mode.
If you hear three short beeps, you cannot change it.
After a long beep, you can exit remote retrieval.
), the system
Advertisement
Table of Contents
