Harness Strap Remove/Replace - Diono radian 3 RXT Instruction Manual

All-in-one convertible

Hide thumbs Also See for radian 3 RXT:

Table of Contents

HARNESS STRAP REMOVE/REPLACE

1. Unzip Back Seat Cover to access harness. Remove

harness straps from the metal hook.

2. Pull the harness straps out from the back of the seat

and remove the Chest Clip and Harness Pads from

each side. Slide the harness strap out of the buckle

tongues.

3. Using a Phillips head screwdriver, take out the

screws and remove the access panel shown. Remove

old harness straps from seat.

4. Insert new harness strap through the slot shown

and pull the strap up.

5. Once the strap is pulled up until the metal D-ring

is located as shown, re-fasten and close the access

panels in step 3.

Slide the new harness straps through the buckle

tongues, re-attach the chest clip and reinstall the

harness pads.

Slide the harness straps through to the back of the seat

and re-install them to the metal hook in Step 1.

1-866-954-9786

ca.diono.com/welcome

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the radian 3 RXT and is the answer not in the manual?

Rainier 2 ax