6.5 Wavelength Automatic Identification
Connect power meter with its matched light source.
Enable light source. Under "Wave ID" operation mode, press
for few seconds. Light source will be enter Wave ID mode.
Hold
shown on the upper right of LCD as an indication.
Once the ID information is detected from light source (press
to 5 seconds, the information on the optical power meter will change automatically according to
the light source. Refer to figure 6-28.
To exit Wave ID mode hold down
to exit Wave ID mode from the light source.
850nm (xxdBm)
1300nm (xxdBm)
850nm (xxdBm)
1300nm (xxdBm)
1310nm (xxdBm)
1550nm (xxdBm)
Matched Light Source
Handheld Optical Power Meter
to exit Wave ID mode from the power mete. Hold down
1310nm (xxdBm)
1550nm (xxdBm)
Meter 6-28
17
. Select desire wavelength.
"--AU" will be
to change wavelength), after 3
Power