Grease Lubrication; Optional Accessories - Makita DUH501 Instruction Manual

4. Remove the screw, and then remove the branch
catcher.
► 1 . Screw 2. Branch catcher
5. Set the angle of a file to 45°, and grind the upper
blade from 3 directions with the file.
► ( 1) File (2) 45°
CAUTION:
Before grinding the shear blades,
make sure that the tool is switched off and the
battery cartridge is removed from the tool.
6. Place the tool upside down, and then remove the
burrs from the shear blades with the file.
1
► 1 . File
7. Set the angle of the file to 45°, and grind the lower
blade from 3 directions with the file.
8.
Return the tool to normal position, and then
remove the burrs from the shear blades with the file.
9. Attach the branch catcher by tightening the screw.

Grease lubrication

Interval of lubrication: Every 100 operating hours
1
1.
2
► 1 . Screw 2. Bottom cover
2.
grease vessel to the hole on the cover by turning the grease vessel.
1
2
► 1 . Cover 2. Grease vessel
3.
4.
5.

OPTIONAL ACCESSORIES

are recommended for use with your Makita tool spec-
ified in this manual. The use of any other accessories
or attachments might present a risk of injury to persons.
Only use accessory or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
•
•
•
•
•
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
15 ENGLISH
Remove 3 screws, and then remove the bottom cover.
1
Remove the cap from the grease vessel, and then attach the
1
Apply the grease to the tool (Approximately 5 g as a guide).
Remove the grease vessel.
Attach the bottom cover, and then tighten 3 screws.
CAUTION:
These accessories or attachments
Shear blade assembly
Shear blade cover
Chip receiver
Grease vessel
Makita genuine battery and charger
2
2