Page 1
SHINDAIWA OWNER’S/ OPERATOR'S MANUAL HT2510 HEDGE TRIMMER WARNING! Minimize the risk of injury to yourself and others! Read this manual and familiarize yourself with the contents. Always wear eye and hearing protection when operating this unit. Part Number 80845 Rev. 5/04...
As an owner/ CAUTION! operator, you’ll soon discover for yourself A statement preceded by the word why Shindaiwa is simply in a class by itself! "CAUTION" contains information that IMPORTANT! should be acted upon to avoid damag- The information contained in this manual ing your unit.
General Safety Instructions Work Safely WORK SAFELY! Shindaiwa hedge trimmers operate at very high speeds and can do serious damage or injury if Always wear close-fitting clothing. Gloves offer they are misused or abused. Never allow a added protection and are strongly recommended.
Throttle Interlock Caution Label Figure 2 IMPORTANT! Caution, Danger, Warning, and Opera- tion Information Labels: Make sure all information labels are undamaged and readable. Immediately replace damaged or missing information labels. New labels are available from your local authorized Shindaiwa dealer.
Air Cleaner ... Non-reversible heavy-duty filter element Starting Method ... Recoil type Stopping Method ... Slide switch,grounding type *Shindaiwa ONE is a registered JASO FC Blade Length ... HT2510-30: 740mm; HT2510-40: 1055mm classified oil and also meets or exceeds Blade Type ... Double-blade cutting action: single-edged blade ISO-L-EGD performance requirements.
10% alcohol by ISO-L-EGD performance requirements. volume! Generic oils and some Shindaiwa One is recommended for use outboard oils may not be intended for in all Shindaiwa low emissions engines. use in high-performance 2-cycle type...
Lead WARNING! The cutters must NEVER engage at engine idle speeds! If the idle speed Cover cannot be adjusted by the above procedure, return the trimmer to your dealer for inspection. Spark Plug Figure 9 Stopping the Engine Ignition OFF...
Gearcase Lubrication 50 Hour Maintenance Every 50 hours (more often in dusty CAUTION! or extreme conditions) ■ Over-lubricating may cause the gearcase to run slower than normal, and may also cause leakage from excess grease. Every 20 Hours Clean VIEWED FROM THE BOTTOM Debris Gearcase Grease...
■ The valve clearance should be adjusted annually or every 135 hours. It is highly recommended that this is done by a Shindaiwa-trained service technician. ■ Replace the spark plug annually: Use only NGK CMR5H or equivalent resistor type spark plug of the correct heat range.
The California Air Resources Board, the U.S. 1. Carburetor Internal Components Environmental Protection Agency and ■ Throttle Valve, Needle, Jet, Metering Shindaiwa Kogyo Co., Ltd. are pleased to Diaphragm explain the emission control system war- 2. Ignition System Components ranty on your new small off-road (non-road) ■...
Page 16
Nishi, Asaminami-ku Tualatin, Oregon 97062 Hiroshima, 731-3167, Japan Telephone: 503 692-3070 Telephone: 81-82-849-2220 Fax: 503 692-6696 Fax: www.shindaiwa.com 2004 Shindaiwa, Inc. Part Number 80845 Revision 5/04 Shindaiwa is a registered trademark of Shindaiwa, Inc. Specifications subject to change without 81-82-849-2481 notice.
Need help?
Do you have a question about the 80845 and is the answer not in the manual?
Questions and answers