Page 1
SHINDAIWA OWNER’S/OPERATOR’S MANUAL LE242/EVC LAWN EDGER others! Read this manual and familiarize yourself with the contents. Always wear eye and hearing protection when operating this unit. WARNING! Minimize the risk of injury to yourself and Part Number 81604 Rev. 11/06...
The Shindaiwa 4 Series hand held power equipment has been designed and built to deliver superior performance and reliability without compromise to quality, comfort, safety or durability. Shindaiwa engines represent the leading edge of high-performance engine technol- ogy, delivering exceptionally high power with remarkably low displacement and weight.
Inspect for broken, missing or improper- ly installed parts or attachments. NEVER use a non-Shindaiwa ap- proved cutting attachment. ALWAYS keep the unit as clean as practical. Keep it free of loose vegeta- tion, mud, etc.
IMPORTANT Safety and Operation Information Labels: Make sure all information labels are undamaged and readable. Immediately replace damaged or miss- ing information labels. New labels are available from your local authorized Shindaiwa dealer.
Federal emission requirements. Category C = 50 hours (Moderate), B = 15 hours (Intermediate) and A = 00 hours (Extended). * meets or exceeds these specifications and is transistor-controlled recommended for all Shindaiwa products. LE242 LAWN EDGER Throttle Ignition Interlock...
Install Gearcase Assembly Figure 5 Assembly and Adjustments Adjust Throttle Lever Free Play The throttle lever free play should be ap- proximately /16-1/4 inch (4-6 mm). See Figure 6. Make sure that the throttle lever operates smoothly without binding. If it becomes necessary to adjust the lever free play, follow the procedures and illustra- tions that follow.
Oil is a registered JASO FC clas- sified oil and also meets or exceeds ISO-L- EGD performance requirements. Shindaiwa One is recommended for use in all Shindaiwa low emissions engines.Shindaiwa One also includes a fuel stabilizer. 1. Place the edger on a flat, level surface.
Starting the Engine Engine ignition is controlled by a two position switch mounted on the throttle housing labeled, “I” for ON or START and “O” for OFF or STOP. Figure 9 1. Slide the ignition switch to the “ON” position. See Figure 9. Return Tube Primer Bulb Figure 10...
The cutting attachment must NEVER rotate at engine idle! If the idle speed cannot be adjusted by the procedure described here, return the trimmer to your Shindaiwa dealer for inspection. ALWAYS make sure the cutting attach- ment is properly installed and firmly tight- ened before operation.
Slowly lower the blade to the ground while applying full throttle. See Figure 16. Do not move the edger into the work so fast that the engine or blade bogs down. CAUTION! Low-speed edging can lead to prema- ture clutch failure.
ESTABLISHMENT OR INDIVIDUAL; HOWEVER, WARRANTY REPAIRS MUST BE PERFORMED BY A DEALER OR SERVICE CENTER AUTHORIZED BY SHINDAIWA CORP. THE USE OF PARTS THAT ARE NOT EQUIVALENT IN PERFORMANCE AND DURABILITY TO AUTHORIZED PARTS MAY IMPAIR THE EFFECTIVENESS OF THE EMISSION...
Page 12
Remove the filler plug from the side of the gearcase and press new grease into the gearcase until grease is pushed out. Use only lithium-base grease such as Shindaiwa Gear Case Lubricant or equivalent. See figure 0. Grease Grease Output...
Page 13
Engine Engine Cover Cover Screws Muffler Gasket Figure 25 IMPORTANT! If you note excessive carbon buildup, consult with an authorized Shindaiwa servicing dealer. Gearcase Protector (P/N 72958-16210) Figure 24 Muffler Cover Muffler Cover Screw Muffler...
. Use the combination wrench to loosen the shaft bolt then remove the output shaft bolt, Holder B and the edger blade from the gearcase. Long Term Storage Whenever the unit will not be used for 0...
Troubleshooting Guide What To Check Does the engine crank? Good compression? Does the tank contain fresh fuel of the proper grade? Is fuel visible and moving in the return line when priming? Is there spark at the spark plug wire terminal? Check the spark plug.
Page 16
Symptom Poor acceleration. Engine stops abruptly. Engine difficult to shut off. Cutting attachment rotates at engine idle. Engine will not idle down. Symptom Excessive vibration. Cutting attachment will not rotate. ADDITIONAL PROBLEMS Possible Cause Clogged air filter. Clogged fuel filter. Lean fuel/air mixture.
You are responsible for presenting your small off-road engine to an authorized Shindaiwa Dealer as soon as a problem ex- ists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 0 days.
Page 20
Shindaiwa, bajo parte alguna falla debido componentes parte otra centro 69-070 (50) Shindaiwa representante contactar debe respon- derechos respecto razonable tiempo completadas reparaciones problema. presente autor- Shindaiwa servicio centro...
Page 24
Tapa Parrilla silenciador Pernos silenciador Tornillo Silenciador mofle tapa Tornillo tapa Cubierta motor 72958-16210) (N/P Engranajes Caja Protector Tuerca Shindaiwa. autorizado distri- servicio centro carbón, excesiva acumulación ¡IMPORTANTE! Maya motor Tapa muestra. como lugar asegurado este firmemente apretados estén...
Page 25
Inserte instalar. hora puntas revertir flexible cable vida extender NOTA: tubo instalar vuelva engranaje caja para equivalente) Shindaiwa Primera Lubricante entera longitud Revista también. remplazarse debe forro reemplazado necesita gastado esta flexible dañado. gastado esta remplace cuidadosamente, Inspeccione vente.
Page 26
Cerciórese faltante. defectuoso silenciador guardachispas operada debe nunca máquina Silenciador Shindaiwa. garantia invalidar podría estándar repuestos NOTA: edo. aire Deje agua sucias (más Cada incendio. riesgo prematuro gasto sobrecalentamiento puede áreas...
Page 27
Shindaiwa. marca lador oril- para cuchillas sólo Utilice ¡ADVERTENCIA! cuchilla. desgaste compensar también requiere guía rueda ajuste NOTA marcha. esta motor mien- guía rueda ajuste Nunca ¡ADVERTENCIA! Figura mente. firme- guía rueda perilla Apriete 17a. Figura deseada. altura guía rueda...
Page 28
PROTEGERSE cabezal USTED rebotes. encaje garan- protección SIEMPRE accesorio doblado, ¡ADVERTENCIA! NUNCA firmemente esté corte equipo SIEMPRE protec- Unidad Condición Shindaiwa devuelva procedimiento mínima marcha mínima Tornillo girar debe Ajuste accesorio permitir debe liberada. cuando debe motor Motor Mínima Marcha “O”...
Page 29
continuación). Mínima” Marcha “Ajuste (Consulte ajustada. debe carburador mínima locidad mínima, marcha regresa motor cuando girando continua corte accesorio girar. pare accesorio permite acelerador liberando rápido; más gire corte accesorio hace acelerador Adelantando máquina. usar antes minutos mínima marcha caliente mita per- motor,...
Page 30
Retire combustible. tapa alrededor despojos suciedad cualquier Retire nivelada. plana superfi- sobre maquina Posicione combustible. estabilizador tambien Shindaiwa emisión. Shindaiwa motores todo recomendado Shindaiwa ISO- rendimiento requisitos cumple tambien clasificado JASO registrado aceite Aceite STA-BIL™. ejemplo como...
Page 31
aire. filtro tapa Reinstale ajustador seguridad Cable Tuerca seguridad. tuercas Apriete figura Consulte mm). pulgadas /16-1/4 apropiada holgura obtener para requerido como fuera dentro hacia ajustador cable pulgada. libras – torsión abrazadera tornillo Apriete asegurarlo. hasta apriete índice tornillo instalar Vuelva eje.
Page 33
Shindaiwa. autorizado local servicio centro ponibles dis- están nuevas Etiquetas faltantes. dañadas etiquetas inmediatamente Reemplace legibles. daños libres estén etiquetas toda Asegurese Operación: Información IMPORTANTE! ¡ instalado. correctamente esté corte cesorio protector cerciórese Siempre corte. cesorio tocarlos evite cuidado extremo eléctricas,...
Page 34
maquina. apagado después inclusive girando continuar puede hoja rotar. físicos daños causar puede cuchilla Cuchilla. alejados pies Mantenga condición. buena esté correctamente instalado esté corte accesorio protector cerciórese Siempre firmemente. mango sujetando manos ambas opere Siempre lanzados. objetos protegerse para seguridad lentes como...
Page 35
Nunca ¡ADVERTENCIA! segura. maquina esta operar para mental condiciones optimas estar debe alerta Mantengase unidad. esta Shindaiwa aprobados accesorios autorizados. accesorios instale Nunca ¡ADVERTENCIA! unidad! esta opere instrucción entrenamiento persona permita Nunca abusadas. usadas lesiones daños...
Page 36
11/06 Rev. 81604 pieza Número máquina. esta opere cuando oídos ojos para protección Siempre contenido. iaricese famil- manual este otros! lesiones causar lesiones sufrir riesgo Disminuya ¡ADVERTENCIA! LE242/EVC GRAMA ORILLADORA SHINDAIWA PROPIETARIO/OPERADOR MANUAL...