Tub Clean - LG FH069FD2FS Owner's Manual

7. Tub clean -

To clean up the tub, please run the TUB CLEAN cycle.
Entering Tub Clean
in ready/idle mode.
Pay type: Price is
displayed.
OPL type: PUSH is
displayed.
Entering set up
mode.
You will see LqC1
NOTE
• Never load laundry while using TUB CLEAN. The laundry may be damaged or become con-
taminated. Make sure to clean the washer tub when it is empty.
• Leave the door open after finishing the laundry to keep the tub clean.
• TUB CLEAN should be repeated monthly.
• Safely and conveniently secure the door slightly ajar with a magnetic door plunger. This will
promote air circulation and allow the interior of the machine to dry.
Press and hold the 75°C (167°F) button for at least 3
seconds.
Display shows default number of Tub Clean cycle runs
per operation.
Press the 75°C (167°F)(+) or 60°C (140°F)(-) button to
select the number of Tub clean cycle runs. (1~3)
Press the Start button.
Display will show the remaining time and Tub Clean
starts.
When the TUB CLEAN cycle is finished,
displayed with beeping.
Go back to ready mode.
Press the 75°C (167°F) or the 60°C (140°F) button until
appears in the display.
Press Start button.
Display show the remaining time and Tub clean Start.
When the TUB CLEAN cycle is finished,
displayed with beeping.
Go back to ready mode.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready
mode.
• Coin type - Turn on/off toggle switch.
• Card type - Pull the service card.
• All types - Push the 90°C (194°F) button twice.
PROGRAMMING MODE - TEST MODE
Button
Button
Display
is
Display
is
71