Sharp Notevision PG-B10S Operation Manual page 51

If you want to change the keycode, follow
the procedure below.
Note
When "Anti-Theft" is selected, the password in-
put box will appear. After the password has been
entered, you can change the keycode.
1
Press the buttons on the remote
control or the projector to enter the
preset 4-digit keycode in "Old
Code".
2
Press any button you like on the re-
mote control or the projector to en-
ter the new keycode.
3
Enter the same 4-digit keycode in
"Reconfirm".
Note
If you do not want to set a keycode, leave the
keycode field blank in steps 2 and 3 and press
.
If you want to clear the keycode input box,
follow the procedure below.
MKeycode input box
Note
When "Anti-Theft" is selected, the keycode in-
put box will appear.
If no keycode is entered, the image will not be
displayed, even if the projector receives the in-
put signal.
1
Press on the remote control or
on the projector to turn on the
projector.
2
Enter the keycode you set when the
keycode input box is displayed.
Note
When entering the keycode, press the buttons
previously set on the projector or the remote
control.
-47