Installation Requirements - Sharp AR-M451N Operation Manual

INSTALLATION REQUIREMENTS

Improper installation may damage this product. Please note the following during initial installation and whenever the
machine is moved.
1.The machine should be installed near an
accessible power outlet for easy connection.
2.Be sure to connect the power cord only to a
power outlet that meets the specified voltage and
current requirements. Also make certain the
outlet is properly grounded.
GFor the power supply requirements, see the
name plate on the back of the main unit.
3.Do not install your machine in areas that are:
Gdamp, humid, or very dusty
Gexposed to direct sunlight
Gpoorly ventilated
Gsubject to extreme temperature or humidity
changes, e.g., near an air conditioner or
heater.
4.Be sure to allow the required space around the
machine for servicing and proper ventilation.
A small amount of ozone is produced within the machine during operation. The emission level is insufficient to
cause any health hazard.
NOTE:
The present recommended long term exposure limit for ozone is 0.1 ppm (0.2 mg/m
weighted average concentration.
However, since the small amount that is emitted may have an objectionable odor, it is advisable to place the copier
in a ventilated area.
0-2
30cm (11-13/16")
80cm
(31-1/2")
60cm (23-5/8")
3 ) calculated as an 8 hr. time-
60cm
(23-5/8")