G Margin Shift; Margin Shift - Sharp AR-M451N Operation Manual

Margin shift

The margin shift function will automatically shift the text or image on the copy paper approximately 10 mm (1/2") in
its initial setting.
This function is convenient when stapling or binding copies with a string.
NOTES
G The initial setting for the margin width can be changed in the key operator programs to any value from 0 to 20
mm (0 to 1"). (Page 15 of the Key operator's guide)
G When margin shift is selected, rotating copying will not operate even if the condition for rotate copying is met.
One-sided copying
Image shifted
Original
to the right
Margin
Two-sided copying
Original
Image shifted
to the right
Or
Margin
To display the special modes screen...
See "General procedure for using special
functions" on page 5-2.
1 Touch the [MARGIN SHIFT] key on the
special modes screen.
SPECIAL MODES
MARGIN SHIFT ERASE
JOB
PAMPHLET COPY
BUILD
2 Select the shift direction.
RIGHT LEFT
Image shifted
to the left
Margin
Image shifted
to the left
Margin
The margin shift setting
screen will appear.
The margin shift icon
( ) will also appear in
the upper left of the
screen to indicate that
the function is turned on.
Touch a shift direction
key to select right or left.
The selected key will be
highlighted.
GThe shift direction can be selected from right or left
shift as shown in the illustration.
3 Set the shift amount as needed and touch
the [OK] key.
OK
CANCEL OK
SIDE 1 SIDE 2
(0 20) (0 20)
10 10
mm mm
4 Touch the [OK] key on the special modes
screen.
You will return to the main screen of copy mode.
About the steps that follow
If an automatic document feeder is being used,
see pages 4-7 through 4-10. If the document
glass is being used, see pages 4-11 through 4-
13.
To cancel the margin shift function, touch the
[CANCEL] key on the margin shift setting screen.
SPECIAL MODES
Use the and the
keys to set the shift
amount. The shift
amount can be set from
0 to 20 mm in 1 mm (0"
to 1" in 1/8") increments.
5-3
5