Advertisement
Connecting the Cables
1
Open the maintenance door at the back of LPU unit.
2
Connect the SDI output of LDC-HD01 to the SDI
input of LPU.
DATA
OUT2
BNC cable
LDC-HD01
CONTROL
POWER
ON
OFF
GENLOCK
REMOTE
IN
OUT
AC IN
LAN
RS-232C
ACT
LINK
MODE SW
FG
— ON —
3
Connect between each LPU by daisy chaining.
Notes
• Daisy chaining is a connection method by which the
output of the 1st unit is connected to the input of the
2nd unit, and then the output of the 2nd unit is
connected to the input of the 3rd unit, etc.
• Input : DATA IN
• Output : DATA OUT1 or DATA OUT2
4
For less than 64 units
The output of the last unit is connected to the return
terminal of LDC-HD01.
For more than 64 units
The output of every 64th unit connects to a Switcher
input (up to 4 inputs can be connected), and the output
of the Switcher is connected to the return terminal of
LDC-HD01.
DATA
DATA
OUT1
IN
4 HD OUTPUT
INPUT
VIDEO
IN
OUT
HDMI
MONITOR
SD/HD SDI
DVI
IN
OUT
RETURN IN
1
2
3
4
Notes
• If the cable length is less than 100 m (328 feet), Canare
L-5CFB 75 ohm BNC cable (or equivalent) can be used.
• If the cable length is more than 100 m (328 feet), optical
fiber cable should be used, with an Optical Media
Converter (not supplied) used in-between.
* Data transmitting rate: 600 Mbps
• The provided cable should be used for the connection
between each LPU.
• Consult a Sony representative for information about the
Switcher unit.
7
Connecting the Cables
Advertisement
