Terminal Emulation - Sharp IQ-8920 Operation Manual

5. Enter your text.
Enter a J after each command.
l
Search strings (entered using the S command) must be
l
entered exactly as the system you're calling normally
displays them. This means that you must enter upper-
and lower-case letters in the auto log-on set-up exactly
as those letters are shown when logging on manually.
You may have to log onto a system manually at least
once to copy the system's text strings in order to write
a log-on procedure.
6. Touch w] when you have finished to store the auto
log-on text.
The Setting display appears.
7. Touch m again to store the entry.
Terminal There are two terminal emulation modes available on this
unit: TTY (teletypewriter) and the more advanced
emulation
formatting controls and enhanced text handling and
display. Select the one the remote computer/system
which you are communicating with supports in the dialing
entry.
You can then configure your terminal using the last six
parameters in the entry (WRAP AROUND, TAB, AUTO
REPEAT, CURSOR, CURSOR TRANSLATE
requirements.
While the unit's default settings will work fine for virtually
all of your telecommunications, you may at some time
find the need to change the emulation settings. (See p.
In VT-100 emulation mode, you can use a VT-1 00
numeric keypad, which can be used like the function keys
on a standard computer, on the unit display. To use this in
on-line mode,
1. Press (m) , touch I[ , and select POP UP
NUMERIC KEYPAD.
stands for "video terminal"), which adds greater