Download  Print this page

AEG ABE81826NC User Manual page 12

Hide thumbs

Advertisement

12
www.aeg.com
Problem
A
or
instead of numbers on the
Temperature Display.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the "Frostmatic",
or after changing the tem-
perature.
Temperature cannot be set.
dEMo appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
Possible cause
Temperature sensor prob-
symbol is shown
lem.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The "Frostmatic function"
is switched on.
This is normal, no error has
occurred.
The "Frostmatic function"
is switched on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The food products' tem-
perature is too high.
The door has been
opened often.
Solution
Contact the nearest Author-
ised Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
Refer to "Operation".
Wait few hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "Frostmatic function".
The compressor starts after a
period of time.
Switch off "Frostmatic func-
tion" manually, or wait until
the function resets automati-
cally to set the temperature.
Refer to "Frostmatic function".
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and dis-
play shuts off for a short time.
Set a higher/lower tempera-
ture.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Open the door only if necessa-
ry.

Advertisement

loading

  Also See for AEG ABE81826NC