Sharp PN-V601 Operation Manual page 38

Specifications
nDimensional Drawings
Note that the values shown are approximate values.
5-7/8
[149.3]
3-5/8
[92.3]
When mounting the monitor, be sure to use a wall-mount bracket that complies with the VESA-compatible mounting method.
SHARP recommends using M6 screws and tighten the screws.
Note that screw hole depth of the monitor is 3/8 inch (10 mm). Loose mounting may cause the product to fall, resulting in
serious personal injuries as well as damage to the product. The screw and hole should come together with over 5/16 inch
(8 mm) length of thread. Use a bracket which has been approved for UL1678 standard, and which can endure at least 4 times
or more the weight of the monitor.
nPower management
This monitor conforms to VESA DPMS and DVI DMPM. Both your video card and computer must support the same standard in
order for the monitor's power management function to work.
DPMS: Display Power Management Signaling
DPMS Screen
ON STATE Display
STANDBY
No
SUSPEND
display
OFF STATE
*1 When PN-ZR01 (optional), or PN-ZB02 (optional) is not
connected.
*2 When AUTO INPUT CHANGE is set to OFF.
nDDC (plug and play)
The monitor supports the VESA DDC (Display Data Channel) standard.
DDC is a signal standard for plug and play between monitors and computers. Information about resolution and other parameters
is exchanged between the two. This function can be used if the computer supports DDC and it has been configured to detect
plug-and-play monitors.
There are several types of DDC, depending on the communication method used. This monitor supports DDC2B.
38
E
52-5/8 [1335.9]
52-5/8 [1335.9]
Opening width (52-5/16 [1329.4])
Power
Hsync Vsync
1
consumption*
480 W Yes
No
2
1.6 W* Yes
No
VESA holes *
DMPM: Digital Monitor Power Management
DMPM
Yes Monitor ON
Yes Active OFF
No
No
7-7/8 7-7/8
[200] [200]
3-15/16 3-15/16
[100] [100]
Power
Screen
1
consumption*
Display 480 W
2
No display 1.6 W*
Unit: inch [mm]