Table of Contents
Advertisement
Refitting the rear wheel and the silencers
Lubricate the wheel shaft threaded end with
recommended grease.
Fit the rear wheel (10) by engaging shafts (11) in the
relevant seats on the wheel.
Install the tapered spacer (9) and washer (8).
Note
The tapered side of the spacer must be facing
the wheel.
Apply the specified grease to the nut (7) and screw it
by hand on the wheel shaft.
Tighten the nut (7) to a torque of 230 Nm ± 5%,
checking that one of the grooves on the nut is aligned
with one of the holes on the wheel shaft.
Fit the clip (6), fitting the end into one of the holes in
the wheel shaft.
276
Advertisement
Table of Contents
