Backlighting setting
This function allows adjusting the backlighting
intensity.
To set the backlighting enter the SETTING MENU, use
buttons (1) and (2) to select "B.L." and press button (4)
to confirm.
When accessing the function, the active mode
flashes whereas the MENU and EXIT messages will
be steady on.
Use buttons (1) and (2) to select the desired
brightness level (HIGH, MEDIUM, LOW) and press
button (4) to confirm.
Select HIGH to set the display backlighting maximum
brightness - recommended in conditions of strong
ambient light.
Select MEDIUM to set the display backlighting
medium brightness (70%) - recommended in
conditions of medium/low ambient light.
Select LOW to set the display backlighting minimum
brightness (50%) - recommended in conditions of low
ambient light and/or during the night.
To save the new setting, hold button (4) for 2 seconds
while the message "MEM" is highlighted with flashing
frame.
After saving, the display will show MEM-OK for 2
seconds; then, "EXIT" will be highlighted with flashing
frame. To exit the menu and go back to previous page,
press button (4).
Note
In the event of an interruption of the power
supply from the Battery, when power is restored, at
the next Key-On, the backlighting will always be set by
default to maximum brightness.
135