Using External Equipment; Displaying An External Equipment Image; Input Select - Sharp Aquos LC-32D62U Operation Manual

Using external equipment

Displaying an external equipment
image
To view external source images, select the input
source from INPUT on the remote control unit or on
the TV.
Press INPUT.
1
• A list of selectable sources appears.
INPUT SOURCE
Press INPUT again to select the input source.
2
• An image from the selected source automatically
displays.
• Each time INPUT is pressed, the input source
toggles.
• You can also select the input source by pressing
a/b.
• If the corresponding input is not plugged in, you
cannot change the input. Be sure to connect the
equipment beforehand.
NOTE
• See pages 13 to 15 for external equipment connection.
30
TV
INPUT1
INPUT2
INPUT3
INPUT4
INPUT5

Input Select

If the image does not come in clearly from the external
equipment connected to INPUT 1 you may need to
change the input signal type setting on the "Input
Select" menu.
Selecting input signal type (INPUT 1)
Press MENU to display the MENU screen, and
1
then press c/d to select "Option".
Press a/b to select "Input Select", and then
2
press ENTER.
Option
Audio Only
Digital Noise Reduction
Input Select
Output Select
Press a/b to select the signal type you want
3
to set, and then press ENTER.
• If the selected signal type is incorrect, images are
not displayed or displayed without any color.
Auto
COMPONENT
VIDEO
Press MENU to exit.
4
• The setting is stored and can be selected on the
"INPUT SOURCE" menu.
NOTE
• Refer to your external equipment operation manual for the
signal type.
• If you set INPUT 1 to Auto, the TV will automatically select
the input signal.
• Check the operation manual of the external equipment for
the signal type.
• Setting INPUT 1 signal selection to "Auto" when other
equipment is connected will result in the following
connection priority.
INPUT 1:
1 COMPONENT VIDEO
2 VIDEO
[Off]
[Auto]
[Fixed]