Turning On The Server - NEC Express5800/T120h User Manual

Chapter 3 Setup
1.

Turning on the Server

Pressing POWER Switch at the front of the server turns on the server.
Turn on the server by using the following procedure.
Turn on a display, an Uninterruptible Power Supply (UPS), and other peripherals.
Remove Front Bezel.
When the STATUS lamp flashes green (once per second), wait until the lamp lights in steady state.
Press POWER Switch at the front of the server.
POWER LED flashes green (once per second) and after a while, logo appears on the display.
While logo is being displayed, the self-diagnostic program (POST) runs and diagnoses the hardware.
For details, see Chapter 3 (1.1 POST).
Tips
Wait at least 30 seconds before pressing POWER switch after the server is turned
off.
Confirm that power supply controller is powered on when the power cord
Note
is connected to power supply controller such as Uninterruptible Power
Supply (UPS).
Important
Do not connect/disconnect USB devices during POST.
Express5800/T120h User's Guide
1. Turning on the Server
POWER Switch
179