Raid Controller N8103-191 (Aroc Type-A); Installing N8103-191 Raid Controller - NEC Express5800/T120h User Manual

Chapter 2 Preparations
1.20

RAID Controller N8103-191 (AROC Type-a)

This server provides RAID controller PCI card dedicated slot.

Installing N8103-191 RAID controller

Please prepare the following before installing the option.

Parts included in the option kit

T-15 hexalobular driver
To install the components, follow these steps.
1. Back up all data in the server.
2. See steps 1 to 6 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
3. Position the guide pin of the RAID controller to the connector of the motherboard, firmly insert it from above,
tighten the screws securing it in place.
Important
The surface becomes hot after use so to avoid burns please allow the drive
and internal parts of the system to cool before touching.
Note In order to prevent the damage to electronic components, please start to install the
system after conducting the appropriate anti-static treatment. There is a possibility
of causing electrostatic discharge if appropriate grounding wire treatment is not
conducted.
Express5800/T120h User's Guide
1. Installing Internal Optional Devices
N8103-191
Installation
position
131