NEC Express5800/T120h User Manual page 129

Chapter 2 Preparations
3. Position the guide pin of the RAID controller to the connector of the motherboard, firmly insert it from above,
tighten the screws securing it in place.
4. Connect the SAS/SATA cable from the back plane to the controller port. The SAS/SATA cable is labeled
"Port 1" or "Port 2" respectively. Connect them according to the label number.
5. See Chapter 2 (1.24 Installing Side Cover) to install the side cover of the server.
6. See Chapter 2 (2 Installation and Connection) to conduct installation and connection, and turn the power
supply ON.
Note In order to prevent damage of the system due to improper cooling or elevated
temperature, please do not activate the server or enclosure without implementing
any of component or blank on all of drive bays and device bays.
Express5800/T120h User's Guide
1. Installing Internal Optional Devices
129