Beko AP930 Installation, Operating & Food Storage Instructions page 5

• Loosen the 3 screws of the lower door hinges using a flat tipped screwdriver.
(Do not remove completely)
• If the freezer compartment door is lower than the fridge compartment door, bring
them to the same level by turning the elevation screw on the freezer compartment side
in the direction of arrow using a M6 allen key in the similar way as explained above
on the opposite side.
• If the freezer compartment door is higher than the fridge compartment door, bring
them to the same level by turning the elevation screw on the fridge compartment side
in the direction of arrow using a M6 allen key as illustrated below:
After doing the above adjustments, the doors should be level. If the doors do not close
properly, this might adversely affect the operation and efficiency of the refrigerator.
6
BEFORE FIRST USE & OPERATION
Ice/Water Dispenser
• The minimum inlet water pressure required is 1 bar
• The maximum inlet water pressure allowed is 8 bars
• The appliance must be connected to the cold mains water supply and must never be
connected to the hot water.
•Make sure the anti-condensation switch underneath the display is pressed after
connecting the appliance to the cold mains water supply. (Factory setting is in pressed
position)
• You will need to wait for 12 hours before you get your first ice cubes from the ice
dispenser. If there is less than 16 ice cubes in the ice cube container, ice dispenser may
not operate.
• The dispenser will not be activated if the freezer door is open. Therefore, please make
sure that the freezer door is closed in order to allow the dispenser to start operating.
• In order for the ice/water dispenser to operate smoothly, the water pressure in the
system should be between 1 – 8 bars. To check this, see if 1 glass of water (100 cc) fills
using the dispenser in 10 seconds.
• Do not forget to take out the Ice Hole Cover before using the ice dispenser.
• Water dispenser is automatically activated when the refrigerator starts operating.
However it would take up to 12 hours for the water to chill.
• Approximately the first 30 pieces of the ice cubes made and dispensed should not
be consumed.
• Water may not flow from the dispenser during the initial operation because of the
air trapped in the piping system. Press the latch for about 1 minute three times at intervals
to bleed the air trapped in the system. The uneven flow of the water from the dispenser
will disappear as soon as the trapped air in the system is released.
• The first 10 glasses of water should not be consumed.
• Always make sure that you fit the water filter before using the ice/water dispenser.
7