Anti Junk Fax Setting; Fax Polling Security; Polling Security Setting; Passcode Number Setting - Sharp AR-FX12 Operation Manual

KEY OPERATOR PROGRAMS

Anti junk fax setting

This program is used to enter fax numbers from
which you wish to block fax reception. Up to 50
(maximum of 30 on the AR-M351N/AR-M451N/
AR-M351U/AR-M451U) numbers can be entered.
This program is normally disabled.
To block reception from the entered fax numbers,
touch the [VALID] key.
Entering anti junk fax numbers
1 Touch the [ENTER] key.
The passcode entry screen appears.
KEY OPERATOR PROGRAMS
ANTI JUNK FAX SETTING
ENTER
DEKETE
Enter the fax number with the numeric
2
keys.
Up to 20 digits can be entered.
When you have finished entering the number,
touch the [NEXT] key to store the number. A new
number entry screen will appear. Enter the next
number with the numeric keys.
3 Touch the [OK] key.
Deleting an anti junk fax number
1 Touch the [DELETE] key.
The deletion screen will appear.
Touch the number key that you wish to
2
delete.
A message will appear. Touch the [YES] key to
delete the number.
To cancel the deletion, touch the [NO] key.
8-10

Fax polling security

These settings are for using the Public Box for polling memory.
Note that they do not apply to F-code polling memory. (see
"USING THE POLLING FUNCTION" on page 3-14)
The "Fax polling security" are as follows:

Polling security setting

Passcode number setting

Polling security setting
When performing polling memory (See "polling
security" on page 3-16), this setting is used to select
whether any machine will be allowed to poll your
machine, or only machines that have been
programmed in your machine. Polling security setting
is normally turned on (a checkmark appears in the
box).
To allow any machine to poll your machine, touch the
box to remove the checkmark.
NOTE
If polling security setting is enabled, enter the
numbers of the fax machines to be allowed to poll
your machine in "Passcode number setting" below.
Passcode number setting
When the polling security setting is turned on, use
this setting to program (or delete) the fax numbers of
the machines that are allowed to poll your machine.
Programmed fax numbers are called passcodes. Up
to 10 fax numbers can be programmed.
Programming passcode numbers
1 Touch the [ENTER] key.
The passcode entry screen appears.
KEY OPERATOR PROGRAMS
PASSCODE NUMBER SETTING
ENTER
Touch a blank key (a key in which no
2
number appears).
KEY OPERATOR PROGRAMS
PASSCODE NUMBER SETTING
ENTER
0666211221
Keys with numbers cannot be touched.
If numbers have been stored in all of the keys, a
message will appear and no further numbers can be
stored. First delete a number that is no longer
needed and then store the new number.
OK
DELETE
CANCEL OK
1/2
0743535521