Table of Contents
Advertisement
Purpose of the manual
This manual describes the properties of this module and supports you when installing and
commissioning it.
The required configuration steps are described as an overview and there are explanations of
the relationship between firmware functions and configuration.
You will also find information about the diagnostics options of the device.
Current manual release on the Internet
You will also find the current version of this manual on the Internet pages of Siemens
Industry Online Support in the directory with following entry ID:
51297224 (http://support.automation.siemens.com/WW/view/en/51297224)
Required experience
To install, commission and operate the CP, you require experience in the following areas:
● Automation engineering
● Setting up the SIMATIC S7-1200
● SIMATIC STEP 7 Basic / Professional
Requirements for use of the module
You will find the requirements for using the module in the section Hardware requirements
(Page 15).
Sources of information and other documentation
You will find an overview of further reading and references in the Appendix of this manual.
SIMATIC NET glossary
Explanations of many of the specialist terms used in this documentation can be found in the
SIMATIC NET glossary.
You will find the SIMATIC NET glossary here:
● SIMATIC NET Manual Collection or product DVD
The DVD ships with certain SIMATIC NET products.
● On the Internet under the following entry ID:
50305045 (http://support.automation.siemens.com/WW/view/en/50305045)
Siemens Automation
CP 1243-1 PCC
Operating Instructions, 02/2015, C79000-G8976-C384-01
Preface
5
Advertisement
Table of Contents
