Installing on a DIN rail
To mount the communications processor on a 35 mm DIN rail, you require an additional DIN
rail holder. You can obtain this holder under the article number 6GK1 571-1AA00-0AH0.
When used in hazardous environments corresponding to Class I, Division 2 or Class I,
Zone 2, the device must be installed in a cabinet or a suitable enclosure.
To comply with EC Directive 94/9 (ATEX95), this enclosure must meet the requirements of
at least IP54 in compliance with EN 60529.
Operating Instructions, 02/2018, C79000-G8976-C283-05
Upper DIN rail holder
Lower DIN rail holder with spring catch
Spring DIN rail slider
3.4 Installing on a DIN rail