Siemens Sinumerik 802D sl Instruction Manual page 5

Preface
SINUMERIK Documentation
The SINUMERIK documentation is organized in 3 parts:
S General Documentation
S User Documentation
S Manufacturer/Service Documentation
More detailed information about other publications concerning SINUMERIK 810D and 840D
and publications that apply to all SINUMERIK control systems (e.g., Universal Interface,
Measuring Cycles, etc.) can be obtained from your local Siemens branch office.
A list of documents, updated on a monthly basis, is available on the Internet for the available
languages at:
http://www.siemens.com/motioncontrol
Select "Support"/"Technical Documentation"/"Overview of Documents".
The Internet version of the DOConCD (DOConWEB) is available at:
http://www.automation.siemens.com/doconweb
Target readership of this documentation
This document is designed for machine tool manufacturers. This publication provides detai-
led information that the user requires for operating the SINUMERIK 810D sl.
Standard version
This Instruction Manual describes the functionality of the standard scope. Extensions or
changes made by the machine manufacturer are documented by the machine manufacturer.
Other functions not described in this documentation might be executable in the control. This
does not, however, represent an obligation to supply such functions with a new control or
when servicing.
Hotline
If you have any questions, please contact the following hotline:
If you have any comments, suggestions, or corrections regarding this documentation, please
fax or e-mail them to:
Fax form: See the reply form at the end of the brochure.
Siemens Automation Parts
SINUMERIK 802D sl Instruction Manual (BA), 05/2005 Edition
6FC5 397-0CP10-1BA0
A&D Technical Support
Phone: +49 (0) 180 / 5050 – 222
Fax: +49 (0) 180 / 5050 – 223
Internet: http://www.siemens.com/automation/support–request
Fax: +49 (0) 9131 / 98 – 63315
E-mail: motioncontrol.docu@siemens.com
iii