Basic Operation - Sharp PN-E601 Operation Manual

2
5
7
8
1. INPUT (Input mode selection)
The menu is displayed. Press
mode, and press to enter.
* You can select the input terminal by pressing the input
switch of the monitor.
Input mode
PC D-SUB PC D-sub input terminal
PC HDMI PC/AV HDMI input terminal
AV HDMI PC/AV HDMI input terminal
When the PN-ZB01 (optional) is attached
Input mode
PC DVI-D PC/AV DVI-D input terminal
PC HDMI PC/AV HDMI input terminal
PC D-SUB PC D-sub input terminal
PC RGB PC RGB input terminals
AV DVI-D PC/AV DVI-D input terminal
AV HDMI PC/AV HDMI input terminal
AV COMPONENT AV COMPONENT input terminals
AV S-VIDEO AV S-video input terminal
AV VIDEO AV video input terminal
*1 Select the terminal to be used in HDMI of INPUT SELECT.
(See page 12.)
*2 Select the terminal for AUDIO SELECT which is used for
audio input. (See page 12.)
*3 Select the terminal to be used in DVI of INPUT SELECT.
(See page 12.)
*4 Select the terminal to be used in BNC of INPUT SELECT.
(See page 12.)
2. MUTE
Turns off the volume temporarily.
Press the MUTE button again to turn the sound back to the
previous level.

Basic Operation

1
3
4
6
or to select the input
Video Audio
Audio input terminal
*1
*2
*1
Video Audio
*3
*1
*4
*3 *2
*1
*4
3. MENU
Displays and turns off the menu screen (see page 7).
4. VOL +/- (Volume adjustment)
Pressing or displays the VOLUME menu when the
menu screen is not displayed.
V O L U M E
Press or to adjust the volume of the sound.
* If you do not press any buttons for about 4 seconds, the
VOLUME menu automatically disappears.
5. BRIGHT +/- (Backlight adjustment)
Pressing or displays the BRIGHT menu when the
menu screen is not displayed.
B R I G H T
Press or to adjust the brightness.
* If you do not press any buttons for about 4 seconds, the
BRIGHT menu automatically disappears.
6. SIZE (Screen size selection)
The menu is displayed.
Press
or to select the screen size. (See page 6.)
7. DISPLAY
Displays monitor information. When you press this button
again, the display disappears.
When the PN-ZB01 (optional) is attached, the display changes
from INFORMATION1 → INFORMATION2 → clear display,
and so on every time you press this button.
• The display disappears automatically after about 15
seconds.
• is displayed during LAN communication.
LAN
• If is displayed in red, there is a duplicate IP address.
LAN
8. MODE (Color mode selection)
Each time you press this button, the color mode changes in
the following order:
STD (Standard) → VIVID → sRGB → STD...
• sRGB applies to PC input only.
sRGB is international standard of color representation
specified by IEC (International Electrotechnical
Commission). Color conversion is made in taking account
of liquid crystal's characteristics and represents color tone
close to its original image.
15
15
5
E