Rear Panel I/O Ports
DVI-I
COM 1
(DVI-D signal)
PS/2 KB/MS
USB 2.0
VGA
DP++
The rear panel I/O ports consist of the following:
•
1 PS/2 Keyboard/Mouse port
•
2 USB 2.0 ports
•
1 Serial COM port
•
1 VGA port
•
1 DVI-I (DVI-D signal) port
•
1 DP++ port
•
2 RJ45 LAN ports
•
4 USB 3.1 Gen 1 ports
•
1 Line-in jack (optional)
•
1 Line-out jack
•
1 Mic-in jack
Chapter 2 Hardware Installation
Chapter 2
LAN 1
LAN 2
Line-out
Mic-in
USB 3.1 Gen 1
PS/2 Keyboard/Mouse Port
PS/2 Keyboard/Mouse
This rear I/O port is used to connect a PS/2 keyboard/mouse. The PS/2 mouse port uses
IRQ12.
Wake-On-PS/2 Keyboard/Mouse
The Wake-On-PS/2 Keyboard/Mouse function allows you to use the PS/2 keyboard or PS/2
mouse to power-on the system. To use this function:
• BIOS Setting
Configure the wake-up function of PS/2 keyboard/mouse in the Advanced menu ("ACPI Con-
figuration" submenu) of the BIOS. Refer to the chapter 3 for more information.
Important:
The +5V_standby power source of your power supply must support ≥720mA.
21
Battery
A61
A61
www.dfi .com