General Configuration; Navigating User Menus; User Menu - Honeywell XYR 5000 Series User Manual

Honeywell Industrial Wireless
4.

General Configuration

Rev 5
08/06
This section discusses general configuration of the Transmitter via
the NEXT and ENTER buttons. The subsections are as follows:

4.1: Navigating User Menus

4.2: Transmitter Displayed Messages
4.3: Overall Configuration Menu Map
4.4: Setting the Transmitter Tag Name
4.5: Setting a User Password
4.6: Resetting All Transmitter Settings
4.1. Navigating User Menus
Pressing either the NEXT or ENTER buttons located on the front of
the Transmitter or Base Radio just below the LCD screen is all that
is needed to navigate the respective menus. Pressing both of these
buttons for one second will turn the unit on.
Pressing the NEXT button at any time while the Transmitter is
cycling through the normal messages causes the Transmitter to
enter the setup mode. The NEXT button is then used to step
through menu options, and the ENTER button is used to enter a sub
menu of what is displayed on the LCD at that time. If no button is
pressed within a 30 second period the unit goes back to the normal
display mode.
If you enter a sub menu that requires a numerical input, such as
001, the left most 0 will be blinking. This indicates that pressing the
NEXT button will increment this value with each press from 0 to 9
and back to 0 again. Pressing the ENTER button will move to the
next available value. If the last value is blinking, pressing ENTER
will save the entered values and return from the sub menu.
If both the NEXT and ENTER buttons are depressed at the same
time, a message on the LCD displaying OFF? will appear. If both
buttons are released upon appearance of this message the user will
be returned to the scrolling main screen. If both buttons are not
released for the duration of the OFF? message, you will be
prompted for the password. Upon entering the correct password, the
unit will power down and turn off.
Note If the unit is turned off while entering values in a sub menu,
those values will NOT be saved.
Note There are several menu options that will automatically turn off
if you are using WMT. All changes to these Transmitter menu
options should then be made through WMT instead. This is to
prevent simultaneous changes from taking place. If you wish to
discontinue use of the software and want these menus re-instated,
you must contact your Honeywell Sales Representative.
User Manual
Wireless Dual Discrete Input Transmitter
- 24 -