AEG BMG 4906 Instruction Manual & Guarantee page 80

AEG_BMG_4906_BedAnl_80x80_3.qxd
GB
Save, retrieve and delete measuring data
a. Save data
After each measurement of the blood pressure, the data of the systolic/dia-
stolic pressures, heart rate, and the time and time of the respective measu-
ring cycle are automatically saved. The last 120 measuring results can be
retrieved from the device's memory (e.g., the measuring result no. 21 of
25/06, 18:30h). If the number of measuring cycles exceeds 120, the oldest
data in the memory are automatically deleted.
b. Retrieve data
(1) Only after a measuring cycle, you can use the – or + buttons to retrieve
measuring data saved at an earlier date, if there are any (see Fig.). When
the device is ready to measure (fig. A), press first the button MODE and
then the button – or +.
(2) To select the next line of saved measuring data repeatedly push the - or +
buttons. The retrieved measuring data shown
on the display are numbered accordingly.
After reading-off the stored measurement
data, keep pressed the button START, so
that the time can be indicated on the display.
c. Delete data
(1) In order to delete one data record, select the
desired memory location number with the
button - or +. Keep pressed simultaneously
the button MODE and the button – for
approx. 2 seconds. The indication „dL", (fig.
D), and afterwards the fig. E appear on the
display.
80
19.02.2008 17:35 Uh