Table of Contents
Advertisement
Bootloader
To start a previously loaded Bootloader on the 56F805 board, the following jumper settings are
needed:
•
Set jumper JG5, "Enable on-board Parallel JTAG Host Target Interface"
•
Set jumper JG7, "Select DSP's Mode 0 operation upon exit from reset"
•
Set jumper JG9, "Enable RS-232 output"
1.1.2.1.4
56F807
To load the Bootloader into the 56F807 board, the following jumper settings are needed:
•
Set jumper JG7, "Select DSP's Mode 0 operation upon exit from reset"
•
Leave jumper JG9, "Enable RS-232 output", in its default setting (NC)
•
Remove jumper JG4, "Enable on-board Parallel JTAG Host Target Interface"
To start a previously loaded Bootloader on the 56F807 board, the following jumper settings are
needed:
•
Set jumper JG4, "Enable on-board Parallel JTAG Host Target Interface"
•
Set jumper JG7, "Select DSP's Mode 0 operation upon exit from reset"
•
Leave jumper JG9, "Enable RS-232 output", in its default setting (NC)
1.1.2.1.5
56F826
To load the Bootloader into the 56F826 board, the following jumper settings are needed:
•
Set jumper JG6, "Select DSP's Mode 0 operation upon exit from reset"
•
Remove jumper JG2, "Enable RS-232 output"
•
Remove jumper JG1, "Enable on-board Parallel JTAG Host Target Interface"
To start a previously loaded Bootloader on the 56F826 board, the following jumper settings are
needed:
•
Set jumper JG1, "Enable on-board Parallel JTAG Host Target Interface"
•
Set jumper JG6, "Select DSP's Mode 0 operation upon exit from reset"
•
Remove jumper JG7, "Enable RS-232 output"
1.1.2.1.6
56F827
To load the Bootloader into the 56F827 board, the following jumper settings are needed:
•
Set jumper JG6, "Select DSP's Mode 0 operation upon exit from reset"
•
Remove jumper JG2, "Enable RS-232 output"
•
Remove jumper JG1, "Enable on-board Parallel JTAG Host Target Interface"
To start a previously loaded Bootloader on the 56F827 board, the following jumper settings are
needed:
•
Set jumper JG1, "Enable on-board Parallel JTAG Host Target Interface"
•
Set jumper JG6, "Select DSP's Mode 0 operation upon exit from reset"
•
Remove jumper JG2, "Enable RS-232 output"
1-4
Freescale Semiconductor, Inc.
56F8xx: Serial Bootloader User Manual
For More Information On This Product,
Go to: www.freescale.com
MOTOROLA
Advertisement
Table of Contents
