Sharp AL-1655CS Operation Manual page 74

TROUBLESHOOTING AND MAINTENANCE
Lamp indicator
Blinks
Error
indicator
Steadily
lit
MEMORY FULL, PRESS START TO
RESUME.
NO 2-SIDED COPY FROM BYPASS
TRAY.
NO 2IN1 COPY FROM
BYPASS TRAY.
NO 2IN1 COPY WITH MARGIN
SHIFT.
COPY RATIO CAN NOT BE
CHANGED IN 2IN1.
THIS MENU IS NOT SELECTABLE
WITH DATA.
NO XXXX SIZE TRAY
CHECK SPF/RSPF.
START TO RESUME.
LOAD XXXX PAPER INTO TRAY<*>.
NO PC COMMUNICATION; CHECK
CABLE.
72
Indication
Display
INSTALL A TD
CARTRIDGE.
REPLACE THE
DRUM
CARTRIDGE.
TD CARTRIDGE
IS NEAR EMPTY.
A DRUM
CARTRIDGE WILL
BE NEEDED
SOON.
Cause and remedy
The TD cartridge is not installed
correctly. Reinstall the TD cartridge.
The drum cartridge has reached the end of
its life. Replace it with a new drum
cartridge.
Toner is low. Purchase a new TD
cartridge.
Less than 1000 sheets can be printed
with the current drum cartridge.
Purchase a new drum cartridge.
Data is being held in memory. Print the
data or clear it from memory.
Two sided printing or 2 IN 1 copying is
selected when the bypass tray is
already selected ,or the bypass tray is
selected when two-sided printing or 2
IN 1 copying is already selected.
The bypass tray cannot be used. Press
the [TRAY SELECT] key (
a paper tray.
2 IN 1 copy and margin shift cannot be
used in combination. Cancel the
function that was selected last.
Copy ratio can not be changed in 2 IN 1
copy.
This appears if you attempt to change
a user program setting while a print job
is in progress.
There is no paper for printing. Press
the [MODE SELECT] key to switch to
printer mode and follow the instructions
in the display.
("XXXX" indicates paper size)
An original remains on the document
glass, or the original is too thick to
scan.
If the message is not cleared when
there is no original on the document
glass, the underside of the RSPF is
dirty. Clean the underside of the RSPF
(especially areas where black lines
appear.)
Printing is not possible if the paper size
setting is different from the size of
paper loaded in the tray. Load the
same size of paper as the paper size
setting and then press the [START] key
( ). Printing will begin.
("XXXX" indicates paper size. The tray
is indicated in <*>.)
The machine is not correctly connected
to the computer. Check the cable
(when using the scanner function).
Page
85
87
85
87
34
30
35
) to select
35
38
29
35
64
-
24
89
19
46
47