Using The Sharp Twain - Sharp AL-1215 Operation Manual

4
Press the start (
Scanning will start and the scanned data will be transferred to the
application.
• If the following screen appears, select
• If step 4 is performed with the "Show
Opening the scanner driver and scanning from your computer
Follow the steps below to open the scanner driver setup screen. As an example, this
instruction is given using Sharpdesk as an image capture application.
• Scanning is not possible during a copy and print job.
• The method for starting the scanner driver differs depending on the
• When using the scanner driver to scan an original that has been

Using the SHARP TWAIN

1
Place the original(s) you wish to scan on the original table/SPF/
RSPF.
For the procedure for placing the original, see "ORIGINAL PLACEMENT"
(p.47).
2
After starting Sharpdesk, click the
"File" menu and select "Select
Scanner".
40
Button Manager and click "OK". Button
Manager starts and the application
associated with Button Manager starts. If
you want only Button Manager to start in
this case, set up Button Manager for use in
Windows as explained in "Setting up the
Button Manager" (p.34).
TWAIN setting screen when scanning"
checkbox selected in the Scan Button Destination Setting Dialog Box
(p.36), the TWAIN settings screen (p.41) will automatically appear.
Check the settings, and then press the start (
the "Scan" button in the TWAIN setting screen to start scanning. The
scanned data will be transferred to the application.
type of application. Refer to the manual or the help file of your
application.
placed in the SPF/RSPF. If you perform a pre-scan (see the online
manual or the help file for the scanner driver), the original in the SPF/
RSPF will be output to the exit area after scanning. To scan the
original after the pre-scan, place the original in the SPF/RSPF once
again.
) key.
) key again or click
Click here