Error Analysis And Recovery - Beko Plasma TV User Manual

ERROR
Complete screen fault although the mains lead is connected
and the device is on with network key and the remote
control.
ERROR
Dark screen
ERROR
No colour or excessive colour
ERROR
No/Bad vertical and/or horizontal synchronization
ERROR
The remote control does not function.
ERROR
Displayed image too dark.
ERROR
No signal on the screen.
ERROR
Single letters are not displayed (In PC Mode)
ERROR
Horizontal lines in TV or Video signals.
Repairs
WARNING

Error Analysis and Recovery

POSSIBLE CAUSE
• Power supply has been cut
• Faulty fuse
• Faulty mains lead
POSSIBLE RECOVERY PROCEDURE
• CALL the service support line.
POSSIBLE CAUSE
• Contrast setting too low.
• No input signal
POSSIBLE RECOVERY PROCEDURE
• Adjust brightness and/or contrast correctly.
• Connect the cable correctly and check the video source.
POSSIBLE CAUSE
• No signal from the PC for missing colour
• Bad signal connection
POSSIBLE RECOVERY PROCEDURE
• Check the PC/video source
• Connect the cable properly
POSSIBLE CAUSE
• Bad connection of the synchronization lines
• Bad signal connection
POSSIBLE RECOVERY PROCEDURE
• Screw the plugs and sockets in use correctly
• Check the separate video connection lines
POSSIBLE CAUSE
• Empty batteries
• Blockage between the remote control and the sensor.
• Remote control is out of operation range.
POSSIBLE RECOVERY PROCEDURE
• Insert new batteries.
• Remove the blockage between the remote control and
the sensor.
• Operate the remote control in the given range.
POSSIBLE CAUSE
• Image screen quality not set properly
POSSIBLE RECOVERY PROCEDURE
• Correct the image brightness and contrast.
POSSIBLE CAUSE
• You have selected the wrong input channel.
• The screen cannot be operated with the given signals.
POSSIBLE RECOVERY PROCEDURE
• Switch to the proper input.
• Adjust the signal to the proper format.
POSSIBLE CAUSE
• Switch to the proper input.
• Adjust the signal to the proper format.
POSSIBLE RECOVERY PROCEDURE
• Adjust the proper phase position.
• Check the image size setting.
• Carry out automatic adjustment.
POSSIBLE CAUSE
• The signal source is in front of the screen.
• Video cable protection is insufficient.
POSSIBLE RECOVERY PROCEDURE
• Always place the signal sources next to or behind the
screen.
• Use only high quality signal cable with higher screen
damping.
Do not repair the screen yourself! Otherwise, your guarantee
will be invalid in addition to personal risk.
In case there is an irreparable error, please call the Service
Support Line. It is possible to repair your device fast and for
low cost thanks to the modular design of the screen. Any
intervention to the device apart from the private external
adjustments, especially the removal of protective covers
should be performed by the trained personnel in accordance
with VBG4 (Accident Prevention Regulations, workplace
safety).
ENGLISH -31-