4-Start; Aerial Connection; Powering On Your Tv And The Initial Use; Batteries - Beko 40WLU550FHID Operation Instructions Manual

Start
4
Remove your television carefully from its
box. You can keep the packaging of your
television to use in future.
Contents of the box
Power cable
Remote control

2 batteries

Note: Scart, HDMI, VGA and PHONO
cables are not supplied with the device.

4.1-Aerial connection

4.2-Powering on your TV and
the initial use
1. Insert the power cable into the power
supply input located on the back panel of
the LCD TV.
2. Insert the power cable plug supplied with
the device into the mains socket.
OR
Not 1: Your TV will switch to the STANDBY
mode in five minutes if there is no broadcast
signal from the aerial.
Note 2: Your TV is equipped to operate with
TV buttons in case your remote is broken or
the batteries are exhausted.
3. To power on your television,
press any numerical key or PR+ or
PR- keys on the remote control.
For this process, you can also use
the buttons on your TV. The picture
will appear on the screen after a
short while.
Note: If you are not going to use your
television for a long time, unplug its power
cable from the socket.
Initial power on and performing
settings
To set up your television, read the sections
on the TV controls and making the channel
settings.
4.3-Batteries
Open the lid of the battery compartment
and make sure that you have placed the
batteries in the correct direction. For this
remote control, UM-4, IEC R03 or AAA 1.5 V
batteries are suitable.
Do not throw your old batteries into the fire,
discard them in a dedicated waste area for
this purpose.
Do not mix used batteries with new ones or
different types of batteries together.
The performance of the remote control will
be reduced at a distance of 8 meters from or
at an angle of 30 degrees beyond the centre
of the TV.
7