Advertisement
OPERATING INSTRUCTIONS
TROUBLESHOOTI NG GUI DE
PROBLEM
POSSIBLE REASON
1. Batteries discharged.
2. Dead battery (battery
won't hold charge).
HAND VACUUM
3. Contacts between the
WILL NOT
unit and the charging
OPERATE
stand are dirty.
4. No power in electrical
outlet supplying
transformer.
1. The 2 metal pins of
the motorized brush
are not in contact
MOTORIZED
BRUSH WILL NOT
with the vacuum
WORK
cleaner.
2. Motorized brush is
clogged up.
1. Dust cup container is
full.
HAND VACUUM
2. Dust cup filter needs
WILL NOT PICK-
cleaning or
UP OR SUCTION
replacement.
POWER IS WEAK
3. Unit needs
recharging.
1. Dust cup container is
full.
DUST ESCAPING
2. Dust cup filter is not
FROM HAND
installed correctly.
VACUUM
3. Puncture/hole in dust
cup filter.
6
POSSIBLE SOLUTION
1. Charge unit.
2. Replace batteries. (See
page 5.)
3. Wipe and clean dirt from
contacts.
4. Check fuse or breaker.
Replace fuse/reset
breaker.
1. Firmly insert the
motorized brush into the
air-intake nozzle. This
will connect the
motorized nozzle to the
unit power supply.
2. Remove all lint, hair etc.
from motorized brush.
1. Empty dust cup
container
2. Remove dust cup filter
and check for object(s)
in air duct and remove.
Clean or replace dust
cup filter.
3. Charge unit.
1. Empty dust cup
container.
2. Review dust cup filter
installation instructions.
3. Replace dust cup filter.
OPERATING INSTRUCTIONS
Before Use
1. This cordless vacuum is powered by
rechargeable nickel-cadmium
batteries. Before using the vacuum,
charge the vacuum cleaner for a
minimum of 20 hours.
NOTE: Ensure that the On/Off
switch is in the "Off" position
before charging.
NOTE: Peak performance may only
be realized after the unit has been
charged and discharged two (2) or
three (3) times.
IMPORTANT: To maintain peak
performance of your cordless hand
vacuum, it is recommended that the
unit be fully discharged, then
completely re-charged at least once a
month.
2. Store the vacuum cleaner in the
charging base when not in use so that
it is always charged and ready to
use.
Charging Your Vacuum Cleaner
1. Place the charging base
near an electrical power
outlet (120 V., 60 Hz.)
and plug in the chaging
adapter's jack into the
charging base.
2. Plug the charger into wall
outlet.
3. Place the unit in the
charging base. The
charging indicator light
will shine green to
indicate that the vacuum
cleaner is properly
positioned in the
charging base and that
the unit is being charged. (See fig. 1)
NOTE: Ensure that the On/Off
switch is in the "Off" position
before charging.
4. Always return the unit to the charging
base immediately after use so that it
will be ready and fully charged for it's
next use.
Assembly
Note: Dust cup filter must always be
used when operating the hand
vacuum.
1. To open the dust cup compartment,
push the dust cup release button
and remove the dust cup
container. (Fig. 2)
2. Verify that the dust cup filter is
inside, then re-attach the dust cup
container to the hand vacuum.
(Fig. 3)
Fig. 3
3. To attach the crevice tool or the
dusting brush to the hand vacuum,
push the attachment into the
suction hole in the front of the
dust container. (Fig. 4)
Fig. 1
3
Fig. 2
Fig. 4
Advertisement
