ABB DATUM L160 User Manual page 17

...3.2 Setup Level (Level 2)
H150. 2
rSt-n
L130. 8
rSt-n
SPGrAV
1. 0 00
O. A dJ
•1 The maximum and minimum values are reset automatically on power-up and
can also be reset from a digital input – see Section 4.3.3.
•1
Maximum Value
This is the maximum value of the level input since the
maximum was reset.
o reset the maximum value, select rSt-Y then press
the
•1
Minimum Value
This is the minimum value of the level input since the
minimum was reset.
To reset the minimum value, select rSt-Y then press
the
Specific Gravity
Offset Adjustment
An offset can be applied to the level input to enable spot
calibration or the removal of system errors.
1. 0
3 SET UP MODE...
key.
– reset
rSt-Y
– do not reset
rSt-n
key.
– reset
rSt-Y
rSt-n – do not reset
Enter the specific gravity of the liquid to be
measured.
[±10% of engineering range].
8
15