Removing The Ixt-Hh27 From The Docking Station; Switching On The Handheld Terminal; Suspend Mode; Switching Off The Handheld Terminal - Pepperl+Fuchs IPT-HH27 Quick Start Manual

RFID Handheld Reader
16.3

Removing the IxT-HH27 from the Docking Station

Fig. 8: Removing the device from the docking station
16.4

Switching on the Handheld Terminal

In order to switch on the device, press the "C" button and the "red enter" button to the right of
"0" simultaneously until the LED beneath it lights up. You can then release the buttons. The
desktop of your operating system or your usual work environment appears on the display.
16.5

Suspend mode

In suspend mode, the operating system and the application running on it are stopped. The
display is switched off and consequently becomes dark. In suspend mode, the device uses an
extremely small amount of power.
Suspend mode can be accessed by simultaneously pressing the "C" button and the "red enter"
button to the right of "0". Upon leaving suspend mode (same process as under Point 13.6
'Switching on the handheld terminal'), the application and the operating system starts to run
from the same point.
16.6

Switching off the Handheld Terminal

The device is switched off by pressing the three buttons "C"-, "" and "red enter" right of the "0",
whereby the "0" button must first be pressed and held. Then also press and hold the "" button.
Then also press and hold the "red enter" button. Press and hold these three buttons for at least
10 seconds.
30