Sony DCR-IP45 Quick Start Manual page 44

Playing back a tape
Using the Remote Commander
Press DATA CODE on the Remote Commander in the playback mode.
The display changes as follows:
date/time t various settings (SteadyShot OFF, exposure, white balance, gain, shutter
speed, aperture value) t no indicator
Not to display various settings
Set DATA CODE to DATE in the menu settings (p. xx).
The display changes as follows when you press DATA CODE on the Remote
Commander: date/time y no indicator
[a]
[b]
[c]
[d]
[e]
[f]
Various settings
Various settings shows the camcorder's recording information at the time of recording.
In the recording mode, the various settings will not be displayed.
When you use the data code function, bars
(-- -- --) appear if:
– A blank portion of the tape is being played back.
– The tape is unreadable due to tape damage or noise.
– The tape was recorded by a camcorder without the date and time set.
Data code
When you connect your camcorder to a TV, the data code also appears on the TV
screen.
Remaining battery time indicator during playback
The indicator shows the approximate continuous playback time. The indicator may not
be correct, depending on the conditions in which you are playing back. When you close
the LCD panel and open it again, it takes about 1 minute for the correct remaining
battery time to be displayed.
44
Date/time
40min
0:00:23:01
JUL 4 2002
12:05:56 PM
SteadyShot OFF indicator
Exposure mode indicator
White balance indicator
Gain indicator
Shutter speed indicator
Aperture value indicator
Various settings
40min
0:00:23:01
[a]
[b]
[c]
AUTO
50 AWB
[d]
F1.8 9dB
[e]
[f]