Pairing Headset With Audio Source; Switching Bluetooth Connection Flashing On/Off - Sennheiser Travel MM 450 Instruction Manual

1
5
1
2s
5
1
1
3s
1
1
2s
5
6
3
Pairing the headset with an audio source
Press the Master button
flashes 3 times red.
The headset switches off (see "Switching the headset off" on page 15).
Press the Master button
alternately flashes blue and red.
On your audio source, activate the Bluetooth function "Add a new
device".
Proceed as described in the instruction manual of the audio source.
If a suitable audio source is found, the devices will exchange device identi-
fication information. The Star
ascending beep. The devices have identified each other and the headset is
paired with the audio source.
PIN code
When the audio source prompts for a password or PIN code,
enter the default PIN code "0000".
If a connection is established, the
flash blue.
If no device is found within approx. 5 minutes, the
3 times red and you hear a descending beep. The headset will then try for
3 minutes to connect to one of the 5 known audio sources. If this fails, the
headset automatically switches off.
In this case, repeat the necessary steps to pair the headset with the
audio source again.
Switching the "Bluetooth connection" flashing on/off
Switch the headset off (see "Switching the headset off" on page 15).
To switch the "Bluetooth connection" flashing off:
Press the Master button
alternately flashes blue and red.
Press the Volume button
To switch the "Bluetooth connection" flashing
Press the Volume button
Putting the MM 450 into operation
and keep it pressed until the
and keep it pressed until the
LED flashes 3 times blue and you hear an
Star LED continues to slowly
Star
and keep it pressed until the
for more than 3 seconds.
on again:
for more than 3 seconds.
Star LED
Star LED
LED flashes
Star LED
11
DE
EN
FR
IT
ES
NL