Washing The Filter; Cleaning Of Cyclone Cone - Husqvarna DC 6000 Operator's Manual

• Clean the air filter by placing it in a bag and shaking
the dust off. Do not use compressed air or any sharp
objects to clean the air filter as this can cause damage
to the filter.
• The filter is a conical shape and the wider section
should be at the top of the filter container.
• Replace the filter container in its guide groove on the
handle.
• Tighten the container using the clamping brackets.
• Connect the hose connector to the filter container.
• Screw on the handle with the knob.
Washing the filter
The filter is made of a polyester material and can be
washed with water as necessary. Change filter after 500
hours or after 6 months.
• In order to avoid destruction of the finish or ePTFE
membrane clean the filter elements with a gentle soft
jet of water. A strong/sharp jet will destroy the ePTFE
membrane. The cleaning can be supported by a soft
brush.
• Wash the filter elements from top to bottom. Avoid
rubbing or scrubbing on selected spots.
• Dry the filter elements carefully. Approximately one
week at a temperature of 15-20 °C, or at 70 °C during
16 – English
MAINTENANCE
14 hours in the oven. It is important that they are 100%
dry.
• After washing in above mentioned way, the filter
elements can be used again at low pressure drop. The
life time after washing is approximately 60-70 % of the
life time in new condition.
NOTICE! Ensure that the filter is dry before refitting it.

Cleaning of cyclone cone

• Remove the cyclone cone by turning it
counterclockwise.
• Turn the cyclone cone over and empty the dust and
debris on the floor.
• Inspect the gaiter inside the filter container and clean
if necessary.