Stopping; After Work Is Completed - Husqvarna PP 480 HF Operator's Manual

Hide thumbs Also See for PP 480 HF:
Table of Contents

Advertisement

Available languages

Available languages

The display now shows "HUSQVARNA PP-480 HF
PRESS START".
On the saw unit WS 480 HF, the blade's rotation direction
is adjustable.
Press "arrow up" on the remote control unit's membrane
key to select the direction. The display shows "BLADE
ROTATION STANDARD" or "BLADE ROTATION
REVERSE". To change the current selection, press "OK".
This must only be done when the blade is not moving.
Start the blade rotation by pushing and holding the green
start button while turning the control for rotation direction
clockwise. There is a three seconds delay before the
blade rotation starts. You can follow the countdown in the
display. The delay is to cool down the power unit which
can get hot when active and no cooling water is
circulating.
There is no delay If selected mode for water coolant is
ON.
The water cooling starts automatically when the knob for
blade rotation is turned from its zero position. NOTE!
Applies only if the water coolant mode is set to AUTO. The
water flow is adjusted with the ball valve at the incoming
water connector on the power unit.
Start the depth feeding of the blade by turning the depth
feeding control in the desired direction.
Start the saw unit's travel feed by turning the travel feed
control in the desired direction.
Read through the manual supplied with the wall saw for
further instructions in sawing technique.
12 –
English
STARTING AND STOPPING

Stopping

To switch off the blade rotation, turn the blade rotation
control anti-clockwise back to its zero position.
The water coolant is turned off automatically with a 3 sec
delay. NOTE! Applies only if the water coolant mode is set
to AUTO.
Also turn the depth feeding and travel feeding controls to
their zero positions.
Turn the main switch on the power unit to "0"-position.

After work is completed

Dismantling the equipment
Disconnect the incoming power lead and incoming water
hose.
Disconnect the power lead and water hose between the
power unit and the saw unit.
If there is a risk of freezing, the machine must be drained
of any remaining water coolant.
Cleaning
Make sure to keep the connectors and pins clean. Clean with
a rag or brush.
Do not use a high pressure washer to clean the power unit.

Advertisement

Table of Contents
loading

Table of Contents