Rear - Sony XCL-S600 Technical Manual

Rear

e DC IN (DC power input) connector (12-pin)
e DC IN (DC power input) connector (12-pin)
You can connect a camera cable CCXC-12P05N etc. to
input the +12 V DC power supply.
For details on the pin arrangement, see the following
table.
Pin No. Signal
1 Ground
2 DC +12 V
3 ISO Ground
4 GPI1/GPO1
5 GPO2(ISO-)
6 GPO2(ISO+)
Power input
Pin 1 (Ground) and pin 2 (DC +12 V) are used.
Signal input
Pins 4, 7, 10 and 11 (GPI1/3/4/2) are used for GPI input
or trigger input.
When selecting 1 system for GPI (ISO):
– GPI4 (ISO+) (pin 10) and GPI4 (ISO-) (pin 8) are
used.
When selecting 2 systems for GPI:
– GPI1 (pin 4*) and Ground (pin 1) are used.
– GPI3 (pin 7*) and Ground (pin 1) are used.
* Pins 4 and 7 can switch GPI input and GPO output, by
external command. The initial value is GPI.
Signal output
Pins 4, 6, 7 and 9 (GPO1/2/3/4) allow you to select GPO
from the exposure signal, strobe control signal, Hi/Low
fixed value, etc.
When selecting 2 systems for GPO (ISO):
– GPO4 (ISO) (pin 9) and ISO Ground (pins 3 and 12)
are used.
f DIGITAL IF (Interface) connector (26-pin mini connector)
g Status LED
Pin No. Signal
7 GPI3/GPO3
8 GPI4(ISO-)
9 GPO4(ISO)
10 GPI4(ISO+)
11 GPI2
12 ISO Ground
– GPO2 (ISO+) (pin 6) and GPO2 (ISO-) (pin 5) are
used.
When selecting 2 systems for GPO:
– GPO1 (pin 4*) and Ground (pin 1) are used.
– GPO3 (pin 7*) and Ground (pin 1) are used.
* The initial value of pins 4 and 7 is GPI. Switch to GPO
output by external command.
f DIGITAL IF (Interface) connector (26-pin)
You can connect a Camera Link cable to this connector
to control a camera module from a host device utilizing
the serial communication protocol while outputting a
video signal from the camera module. You can input the
external trigger signal via the DIGITAL IF connector
and operate a camera module in the external trigger
mode.
The following table shows the relation between the pin
numbers of the DIGITAL IF connector and the input/
output signals and the like.
Pin No. Signal
1 Ground
2 X0–
3 X1–
4 X2–
5 XCLK–
6 X3–
7 SerTC+
8 SerTFG–
9 CC1–
10 CC2+
11 CC3–
12 CC4+
13 Ground
Location and Function of Parts and Operation
Pin No. Signal
14 Ground
15 X0+
16 X1+
17 X2+
18 XCLK+
19 X3+
20 SerTC–
21 SerTFG+
22 CC1+
23 CC2–
24 CC3+
25 CC4–
26 Ground
7