Table of Contents
Advertisement
System Components
Video Camera Module
Camera cable
CCXC-12P02N (2 m, 6.6 ft)
CCXC-12P05N (5 m, 16.4 ft)
CCXC-12P10N (10 m, 32.8 ft)
CCXC-12P25N (25 m, 82 ft)
Camera module interface
board
Camera Link cable
(Sony Camera-compatible)
Connection
Camera module
C-mount lens
Power supply
You can supply power via the DC IN connector using the power adapter.
Use DC-700/700CE which is the stable power source free from ripple or noise.
C-mount lens
Use a lens appropriate
for the pixel count of
the camera.
Install the board in a PCI bus slot in devices such as a computer. Select a commercially
available interface board compatible with the Camera Link feature. You can use either a board
that supports PoCL, or one that does not.
Due to the performance of the board, the frame rate may become low according to lack of
processing capacity. To have this product output frames at the highest speed, use a board
corresponding to PCI-Express.
Performance may also be dependent on the host device (e.g., Computer), so consult the
dealer if images are not displayed properly.
This cable connects to the DIGITAL IF connector on the rear panel of the camera module.
Image/control signals are transmitted via this cable.
Select a proper cable as the maximum usable length of a cable differs due to the attribute of
each cable.
Spotted noise may appear in a specific brightness in the window according to the attribute of
the cable. If this noise is an obstacle, shorten the cable.
Camera Link cable
Camera cable
CCXC-12P02N
CCXC-12P05N
Tripod adaptor
CCXC-12P10N
VCT-ST70I
CCXC-12P25N
Camera adaptor
Tripod adaptor
DC-700/700CE
VCT-ST70I (Insulated
type)
Camera module interface board
AC
TRIG
Internal signal
Camera adaptor
output
DC-700/700CE
System Components
5
Advertisement
Table of Contents
