Advertisement
NOTE: This Quick Install Guide is for
experienced users only!
For less experienced users, please refer to the
installation sections of your User's Guide.
TURN THE POWER OFF
A) Configure drive Master/Slave jumper settings.
Channel
Devices Connected
Primary
Main hard disk connected
(always set to MASTER)
Secondary
No devices connected
Secondary
A single device connected as the MASTER
Primary
No IDE hard disk drive present (HDD is SCSI,
Fibre Channel, etc.)
Tertiary (if available)*
No devices connected
*NOTE: Some add-in boards like sound cards have a single EIDE channel available. If this is your only
option, please consult your add-in board documentation regarding its use.
INSTALL YOUR KENWOOD 72X OR 62X TRUEX CD-ROM DRIVE
INTO AN AVAILABLE 5.25" HALF-HEIGHT DRIVE BAY
CONNECT CABLES TO THE KENWOOD DRIVE
INSTALLATION
COMPLETED!
CD-ROM Master/Slave
Jumper Configuration
Slave
Master
Slave
Master
Master
IDE cable
Audio connector
Your Kenwood drive will
automatically be detected
by Windows® 95
or higher.
Congratulations—your Kenwood
drive should be successfully
installed. If there are problems
accessing the drive, refer to the
Troubleshooting section in your
User's Guide, or on our web
site at www.kenwoodtech.com.
If you are still having problems,
please call our technical support center at 1-888-730-4206
Power cable
Advertisement
