SECO-LARM Enforcer Voltage Booster ST-HB105-TTQ Installation Manual

Installation Manual
ENFORCER
ST-HB105-TTQ
Voltage Booster
Introduction:
The ENFORCER voltage booster is a step-up voltage booster. When running DC voltage over long cable runs,
a voltage drops occurs. The ENFORCER voltage booster will boost the voltage to the required operating
voltage to meet the system's needs. It is useful for CCTV DC cameras, access controls, as well as many other
applications where voltage drop is an issue.
Features:
• Compensate DC voltage drops over long cable runs.
• Built-in overload and short-circuit protection.
• Regulated and filtered output.
• Output current protection: 500mA.
• Selectable 12 or 24 VDC output via jumper.
Installations:
1. Remove the cover by tightly pressing the terminal
block's holes and pushing the side mounting
brackets outwardly.
2. Set the desired output voltage to 12 or 24 VDC.
See table 3. The factory default output setting is
12 VDC.
3. Turn on the power of the power supply. Connect
the output wires from the power supply to the
power input terminal blocks. See specification
chart for the power requirements.
4. Use table 2 to check the LED status for the input
and output voltage.
5. To avoid potential damage, use a voltage meter
to check if the voltage reading at the input and
output terminal blocks is correct.
Observe correct polarity.
Note: 1. Use between 16 AWG and 26 AWG wire
for the input and output terminal blocks.
2. Use the included SECO-LARM DC
pigtail connector for easy installation.
6. Connect device to the power output terminal blocks.
7. If the output voltage is low, then turn the rotary
knob clockwise to increase the voltage or counter-
clockwise to decrease the voltage.
Note: If the output voltage set by the jumper is
higher than the input voltage, then the output
voltage stays the same.
8. Replace the plastic cover on the voltage booster
and secure it in the desired location.
®
• Dual-color LED power output indicator:
• Green power input LED indicator.
• Small size for easy installation.

Specifications:

Output voltage:
Input voltage:
Maximum output current:
LED indicators:
Current
Connector:
Overload protection:
Short circuit protection:
Size:
* This ENFORCER voltage booster's efficiency rate is 85%. For more information,
please visit www.seco-larm.com for further details.
Table 1: Adjustable
Table 2: LED indicator chart
LED colors
Table 3: Output voltage selection chart
Output
voltage
12 VDC
24 VDC
– Red indicates a 12 VDC output.
– Blue indicates a 24 VDC output.
12 or 24 VDC, selectable by jumper
Power output LED (red for 12 VDC, blue for 24 VDC)
PTC (Positive Temperature Coefficient)
voltage
Output voltage Adjustable voltage range
12 VDC 12.2 ~ 13.5 VDC
24 VDC 23.0 ~ 25.2 VDC
Indications
Green Input power is connected.
Output voltage is 12 VDC.
Red
Blue Output voltage is 24 VDC.
Jumper setting
A B C
7~12 VDC for 12 VDC
12~24 VDC for 24 VDC
500mA*
Power input LED (green)
Terminal blocks
Built-in
Built-in
" x 2 " x " (64 x 50 x 19mm)
2 1 / 3 /
2 4
output chart