2-24 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
Evaporative Emission Control System Inspection
(Other than US, CA, ID and SEA-B2 Models)
Inspect the canister as follows.
Remove the meter cover (see Meter Cover Removal in
the Frame chapter).
Slide the clamps [A].
Disconnect the hoses [B].
Visually inspect the canister for cracks or other damage.
If the canister has any cracks or bad damage, replace it
with a new one.
The canister is designed to work well through the motor-
cycle's life without any maintenance if it is used under
Inspect the purge valve (see Purge Valve Operation In-
spection in the Fuel System (DFI) chapter).
Check that the hoses are securely connected and clips
are in position.
Replace any kinked, deteriorated or damaged hoses.
Run the hoses according to Cable, Wire, and Hose Rout-
ing section in the Appendix chapter.
When installing the hoses, avoid sharp bending, kinking,
flattening or twisting, and run the hoses with a minimum of
bending so that the emission flow will not be obstructed.