College Bed Lofts Multi-Width Bunk Bed Assembly Manual

Multi-Width Bunk Bed Assembly Instructions

Assembly instructions for Twin/Twin-XL over Full, Twin/Twin-XL over Queen and Full/Full-XL over

Queen bunk bed.

Basically the upper bunk is a Loft Bed with custom notched front legs. Follow the Loft Bed Assembly

Instructions to assemble the upper bunk. Please note the Back Legs are 5-1/2" wide. The Front

Legs are 5-1/2" wide at the top and notched to be 3-1/2" wide below the Upper Bed Rail. The

notched front legs will allow the Low Platform Bed to be placed in-between the inside of the legs.

Please make sure when assembling the upper bunk that you place the notched legs on the front.

https://www.collegebedlofts.com/assembly_instructions.pdf

The bottom bunk is a Low Platform Bed. Follow the Low Platform Bed Assembly Instructions. The

Lower Bunk is a standalone bed that is not attached to the upper bunk. This allows you to be able to

pull out the lower bunk for cleaning underneath.

https://www.collegebedlofts.com/bedsetup/low_platform_assembly.pdf

Page 1 of 2

Table of Contents

Do you have a question about the Multi-Width Bunk Bed and is the answer not in the manual?

Page 1 Multi-Width Bunk Bed Assembly Instructions Assembly instructions for Twin/Twin-XL over Full, Twin/Twin-XL over Queen and Full/Full-XL over Queen bunk bed. Basically the upper bunk is a Loft Bed with custom notched front legs. Follow the Loft Bed Assembly Instructions to assemble the upper bunk. Please note the Back Legs are 5-1/2” wide. The Front Legs are 5-1/2”...
Page 2 Optional Angled Front Ladder If you ordered the optional Angled Front Ladder it attached to the bottom bunk with an Angled Front Ladder Support. It may be installed either on the left or right end. Position the Angled Front Ladder up against the leg. The Angled Front Ladder Support attaches to the front of the lower bed.