Your monitor has a set of 15 factory pre-configured notes (see below). The maximum length of one
single note is 30 characters. It is possible to edit the notes in Configuration Mode (see the
To enter a note:
Scroll if necessary, then select the note you wish to enter. A confirmation dialog box opens:
annotated on the fetal trace if the fetal recorder is on.
By default, notes are printed lengthwise in the direction of the trace, in the space between the FHR
grid and the uterine activity grid. If you prefer, you can configure the recorder to print across the
You can change this in Configuration Mode by changing the
The following are the pre-configured notes from which to choose:
Amniotic Fluid Clear
Amniotic Fluid Not Clear
Micro Blood Analysis
Up to two notes can be printed directly, and the monitor can temporarily store up to a further two
notes, and these are printed after the first two have been recorded. Any further notes are discarded.
For example, if you enter six notes in quick succession, the first two notes you entered are recorded
right away, the next two are stored in memory and then printed when the first two have been recorded,
and the last two are discarded.
If the printing of two notes happens to coincide with the regular recording of the time stamp that takes
place once every ten minutes, the time stamp is delayed until the notes have finished printing.
SmartKey to open the
to enter the note. The note is then shown in the status line of the display, and is
(notes print width wise across the trace).
3 Basic Operation
setting in the