Download  Print this page

Philips FM20/30 Instructions For Use Manual Page 61

Release j.3 with software revision j.3x.xx patient monitoring.
Hide thumbs

Advertisement

Connecting a Transducer to the Monitor
For the FM20 and FM30, you can connect an Avalon CL Cableless Fetal Transducer system interface
cable (red connector) to one of the fetal sensor sockets at the left side of the monitor.
For the FM40 and FM50, you can connect an Avalon CL or Avalon CTS Cableless Fetal Transducer
System interface cable (black connector) to one of the two dedicated black sockets marked "Tele" at
the rear of the monitor, as an alternative to using one of the fetal sensor sockets (red connector) at the
front.
You can plug a fetal transducer, an ECG/IUP patient module, an Avalon CL or
Avalon CTS Cableless Fetal Transducer System interface cable (red connector), or
an external event marker into any of the four fetal sensor sockets marked by the
fetal symbol, or "Fetal Sensors" (depending on geography).
For measuring maternal SpO
SpO
symbol or "SpO
" (depending on geography).
2
2
For maternal non-invasive blood pressure, connect the cuff to the socket marked
with the NBP symbol or "NBP" (depending on geography).
SpO
socket
1
2
2
Noninvasive blood pressure socket
Fetal sensor sockets
3
, connect the sensor to the socket marked with the
2
3 Basic Operation
61

Advertisement

Table of Contents

This manual is also suitable for:

Avalon clFm40/50

Comments to this Manuals

Symbols: 0
Latest comments: